Welding Floor Pans With Flux Core
Single spot weld move etc.
Welding floor pans with flux core. I just did this on my jeep. The flux core wire seemed to spatter more. Settings to weld floor pans with flux core reply 4 on. After tacking the new floor pans it was a bear to clean the old metal.
I have used gasless flux core to do 20 gauge floors up to 24 gauge quarter panels. All butt joints no lap. My one suggestion i can pass on make sure the old metal is clean. Ford truck cab floor panel lh 27.
I went after the welding with just light wire wheeling. I have the the 024 wire and c25 also it is higher quality but when just doing spots the flux core was acceptable if set up properly. Till panel welded in. December 15 2017 01 05 00 pm ok thanks planning on using 030 wire its a goplus 130 welder.
Im a novice welder. I did fight pin holes more with the flux core.